Flexible 8x32 Digital RGB LED Matrix

Flexible 8x32 Digital RGB LED Matrix

Flexible 8x32 Digital RGB LED Matrix

$69.50
SKU
PLP-MATRIX-8X82
Overview

Each LED is individually addressable. You can set each LED as you wish to scroll messages or draw little images.
Wide compatibility. It works great with Arduino, Raspberry Pi, FastLED library, Adafruit NeoPixel Library.
Chainable and bendable design. You can extend the panel by hooking them up one by one with the 3pin JST connectors. Flexible FPCB can be gently bent and curved around surfaces.
May ship with either WS2812B (datasheet) or SK6812 (datasheet) based LEDs. They are the same functionality, look, color order and protocol

LED Quantity: 256
IC Type: SK6812/WS2812B (IC Built in LED)
Wattage: 76.8W/M
Pixel/m: 32*8
PCB Width: 32*8cm
Length of cable: 100mm
Working Voltage: DC 5V
PCB Color: black

This flexible 8x32 RGB full-color LED matrix module is based on WS2812 or SK6812 intelligent control LEDs. Each LED can be independently addressed with RGB pixels that can achieve 256 levels of brightness. That’s 16777216 colors in total with a scanning frequency no less than 400Hz!

These panels require a 5V low voltage input for power which needs to be able to source a good amount of current – up to 5A in most uses (15A if all LEDs are set to bright white, which is NOT recommended). Attached to each flexible LED matrix are two 3-pin JST SM connectors and two sets of bare power cables (input / output), which provide you connections for DC5V+, COM-, DAT, and GND. Needless to say, if you are looking for a large panel of addressable LEDs to fit the contours of almost any surface you’ve come to the right place.

Write Your Own Review
You're reviewing:Flexible 8x32 Digital RGB LED Matrix
Your Rating